(1) The range of application and productivity of the press is made of high strength and corrosion resistant alloy steel.
(2) Barrel: It is a metal cylinder, which is generally made of alloy steel with high heat resistance, high compressive strength, strong wear resistance and corrosion resistance or composite steel pipe lined with alloy steel. The barrel is matched with the screw to realize pulverization, softening, melting, plasticizing, venting and compacting of the plastic, and continuously and uniformly conveying the rubber to the molding system. The length of the general barrel is 15 to 30 times its diameter, so that the plastic is fully heated and fully plasticized.
(3) Hopper: The bottom of the hopper is equipped with a cutting device to adjust and cut the flow. The side of the hopper is equipped with a sight hole and a calibration metering device.
(4) Machine head and mold: The machine head is composed of an alloy steel inner sleeve and a carbon steel jacket, and a molding die is arranged in the machine head. The function of the machine head is to transform the rotating plastic melt into a parallel linear motion, which is evenly and smoothly introduced into the mold sleeve and imparts the necessary molding pressure to the plastic. The plastic is plasticized and compacted in the barrel, and flows into the head forming mold through the neck of the neck through a porous filter plate along a certain flow path. The mold core sleeve is properly matched to form an annular gap with a decreasing cross section, so that the plastic melt is in the A continuous dense tubular coating is formed around the core. In order to ensure the plastic flow path in the machine head is reasonable and eliminate the dead angle of the accumulated plastic, a shunt sleeve is often placed. In order to eliminate the pressure fluctuation during plastic extrusion, a pressure equalizing ring is also provided. A mold correction and adjustment device is also mounted on the handpiece to facilitate adjustment and correction of the concentricity of the core and the mold sleeve. In the previous reply, the waste plastic recovered by the pulverized granulation process was first pulverized into granules by a plastic pulverizer, and then granulated by screening and washing. The waste plastic pulverizer was generally used with 30HP or more, and also Use a small machine, depending on the materials being recycled