Waste Styrofoam Hot Melting Equipment
It is used for crushing all kinds of soft or hard foam plastics to compressed plastic for next pelletizing. It is especially for compressing waste EPS foam products.
1. Adopting deafener low in noise.
2. Adopting removable blades which can be separately removed and sharpened after getting blunt.
3. Suitbale for smashing all kinds of soft ,hard and foamed plastics.
4. Easy to operate and high output
Milon Hot Melted System is used to melt the plastic waste like EPS EPP EPE XPS. The good reduction in volume can be achieved in this manner to save transport and disposal cost.
Compressed block can be reused as high quality granulate by recycling companies and other related manufacturers.
The operator firstly runs the heating system to pre-heat the screw to reach rated temperature, and then throws plastic waste into hopper of the machine, and then the pre-breaker with two rotating knife shafts will crush it into 10~50mm pieces, which are forced by a screw into the extruder system.
Waste Styrofoam Hot Melting Equipment Technical Parameters:
Screen hole diameter
Extrusion center height
3 zones total 10kw
Crusher motor power
Crusher blades quatity
Twin screw 11sets+10sets
Crusher rotation speed
When you finish the Preparation conditions,our fast and professional aftersales service engineer team will go to your factory to install the machine, give you the operating manual, and train your employee until they can operate the machine well.