PPPE Film Squeezing Machine Technical Features:
Dries the plastic film material by squeezing mechanically.
Processes 500 kg to 1000 kg per hour proportional to the system capacity.
Extruder type reducer is used depending on the system capacity.
By transferring the dirty material to the squeezing machine after the washing phase the humidity of the material is minimized via the squeezing method and therefore energy consumption for the second phase at the agglomeration machine is minimized.
Made of heavy duty steel and sheets completely by gas welding manufacture.
The squeezing machine is environmentally protected with protection panels in order to prevent any danger arising around the machine for a number of reasons.
Our machines have TSE, Warranty Certificate, After Sales Compliance Certificate and CE certificate.
While the squeezing rate was at 15% on the previous models, after modifications and improvements that rate reduced to minimum levels.
a)This machine is our new designed machine, made by the advanced Italian techniques, specially screw pressing dewatering design;
b)It is equipped with a electric control cabinet, feeder mouth is easy to control the drying effect;
c)This machine is especially for plastic film, plastic bags, woven bags, Jumbo bags. Solve the drying problem in the past.
d) Instead of the dewatering machine, hot blower in the recycling line.
PPPE Film Squeezing Machine Technical Parameters：
DRAIN AT THE BOTTOM
DRAIN AT THE BOTTOM
HYDRAULIC STATION MOTOR
Film Squeezer machinery is one of the most important machines in the film recycling line. Is used for squeezing the washed film material. Dewaters the film material squeezing it mechanically. with high torque. Hardly disordered, easily maintain machines，Full automatic.
After crushing into pieces, the film, bags will be put into the squeezer.Drived by reducer, the inside screw push the material into the draining warehouse. The moving press warehouse press down through the oil hydro-cylinder, and make up a tapered mouth with the fixed press warehouse, and make the material stay in the draining warehouse until too much material. Then the material will be pressed. Water will be drained outside through the weep holes of the draining warehouse. The hydro-cylinder up-down movement is controlled by the reducer currect. The current standard level can be set. When the currect higher than the level currect, the hydro-cylinder make the press warehouse up, then the material will be squeezed out. When the currect lower than the level currect, the hydro-cylinder make the press warehouse down, and the water go outside to reach the drying effection.